Using an encoder with a two CIM gearbox

Paul Copioli - A guy who is 13 years older than me, but acts about 13 years younger. - Amanda Morrison [more]

		Chief Delphi > Technical > Electrical > CAN
Using an encoder with a two CIM gearbox

10-01-2012, 00:29

davidthefat davidthefat is offline

Alumni

AKA: David Yoon

FRC #0589 (Falkons)

Team Role: Alumni

Join Date: Jan 2011

Rookie Year: 2010

Location: California

Posts: 792

Re: Using an encoder with a two CIM gearbox

If I can remember, the encoder gets installed on the back side of the main shaft. So you would do it with any other way.

__________________
Do not say what can or cannot be done, but, instead, say what must be done for the task at hand must be accomplished.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:58.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.