|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
||||
|
||||
|
Re: Mecanum vs The Barrier
Depends on the rest of your robot. If you need a low center of gravity, or to be close to the ground to pick up balls I would stick with 8"(My team has the 8" and I am unable convince our students not to use them). but if your have other factors that would need a ten get them.
|
|
#17
|
|||||
|
|||||
|
Re: Mecanum vs The Barrier
Quote:
|
|
#18
|
||||
|
||||
|
Re: Mecanum vs The Barrier
Any concerns with the Mecanum wheels getting over the bridges? Is there going to be enough traction to climb the bridge enough to get on it and over it so you can cross or balance it?
|
|
#19
|
||||
|
||||
|
Re: Mecanum vs The Barrier
We have used the same mecanums without replacing any rollers for two years now. They have been over the Breakaway bumps and driven on asphalt during many fairs and celebrations and they are still working as good as ever.
|
|
#20
|
|||
|
|||
|
Re: Mecanum vs The Barrier
Quote:
|
|
#21
|
||||
|
||||
|
Re: Mecanum vs The Barrier
Quote:
Interesting how the wheels are mounted in the video. |
|
#22
|
||||||
|
||||||
|
Re: Mecanum vs The Barrier
I'm curious whether [R17] applies to a set of 4 mecanum wheels. They are available for $180 each, which would be legal under [R14]. However, a single mecanum wheel isn't very useful by itself, so [R17] might make them illegal.
|
|
#23
|
||||
|
||||
|
Re: Mecanum vs The Barrier
buy them individually.
we had no problems with mechanum in 2010, just with everything else falling apart... the bumps were hard on it. depending on your strategy, there may be no need to cross the bump. however, the bridges will be fairly slippery. i've been toying with the idea of having a pair of powered kop wheels that could be pushed down when needed, and lifted off the ground when not. I figure that they would overcome the mechanum's lack of traction, while still allowing strafing when not in use. |
|
#24
|
||||
|
||||
|
Re: Mecanum vs The Barrier
Ha ha! Impressive that you noticed.
|
|
#25
|
|||
|
|||
|
Quote:
I think the real concern is weight. With the SIMs you have invested a huge amount of your weight allowance on your drive train. Still tempting ![]() |
|
#26
|
|||
|
|||
|
Re: Mecanum vs The Barrier
Our robot in 2010 not only could get over the bump at high speeds with rough mecanums, but also seemed to have better traction than the high traction wheels. We were able to win against any other robot in a pushing contest unless they had the same wheels. I also noticed other teams with rough mecanum wheels outpushing most robots. Things can shake loose if you don't use locking nuts and lock-tight, but that was not a problem for us.
|
|
#27
|
||||
|
||||
|
Re: Mecanum vs The Barrier
no they don't. you are buying 4 wheels.
all AM 4 wheel mecanum sets are over $400... and people have been using the sets legally for years under the same $400 rule... |
|
#30
|
|||
|
|||
|
Re: Mecanum vs The Barrier
barrier for the win
![]() |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|