|
|
|
 (I'm sure that Dave is holding his breath for "welding with Jello".) - jgannon [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| (I'm sure that Dave is holding his breath for "welding with Jello".) - jgannon [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Bumper help
It says you need at least 8inch of bumper. Is that total on one side, or on each corner? like can i put 4inch on each side to a total of 8inches?
Also can i put a bumper on a side that has an interior angle? SO a section of the bumper goes into the robot. or only exterior angles? Any help would be great, thanks. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode