cRIO, NI Axis Setup Tool, and Axis Camera Manager can't connect to Camera

[RufflesRidge]

Originally Posted by ekgordon2

Is there any way to completely reset the Axis 260 Camera to factory settings and re-set it up?

Thanks in advance.

The Axis Camera setup describes the process, but basically hold the reset button while applying power. Keep holding it until the lights turn on (I think) then release.

Based on a post by Greg McKaskle in another thread there may be something wrong with the Setup Axis Camera tool, so it's recommended to set up the camera manually for right now.

[ekgordon2]

Originally Posted by RufflesRidge

The Axis Camera setup describes the process, but basically hold the reset button while applying power. Keep holding it until the lights turn on (I think) then release.

It took a few tries, but this worked. I just set the IP address manually using the web interface. Thanks.