Cim-u-lator Gearbox

[Joe Johnson]

Originally Posted by Feroz1325

<snip>
However we are trying to find some CAD drawings or measurements or even pictures!
Does anyone have CAD drawings of these gearboxes?
<snip>

See attached CIM-U-LATOR photos.

I really don't know what Banebots is thinking. It has been out there a year and still know photos on their website. I am confident they'd sell many more if folks could see what they look like.

There is a lot to like about these little guys.

I purchased both versions from Banebots this past fall. I also purchased the AndyMark CIM-sim.

There is a lot to like about the CIM-sim too.

Things not to like too (e.g. I don't like AndyMark's use of clinch studs -- one came out in the sample I purchased. I don't like the low 2.7:1 ratio on the CIM-U-LATOR I don't like that both block the vent holes on the front of the motor - but lots of folks do this, including my own dang self often in the past).

I have just uploaded a bunch of photos of both these gearboxes to Dropbox -- here is a link to the gallery

Good luck.

Joe J.