842 belt test - Chief Delphi

I don't understand why it should matter if your robot is 100% student built, 100% engineer built or somewhere in between. As long as you are Inspired (I word again) FIRST is getting its point and primary goal across. - [more]

		Chief Delphi > FIRST > General Forum
842 belt test

Thread Tools

Rate Thread

Display Modes

15-01-2012, 23:30

farmersvilleRob farmersvilleRob is offline

Registered User

FRC #4084

Join Date: Jan 2012

Location: Farmersville

Posts: 172

farmersvilleRob is infamous around these parts

Re: 842 belt test

I like it as well. I would probably put the driving motor above the actual system and sprocket and chain that to an assembly that runs the belt so the motor doesn't put so much stress into it. I also would extend the belt drive to a 90 degrees angle down as close as you can the the bumper zone on the edge. That would be one hell of a lightweight ball collector.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 21:33.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.