Try starting from scratch, it looks like you've chewed up the default code a bit.
- Rerun the camera setup utility to get the settings right and verify the settings by successfully browsing to the camera at 10.xx.yy.11
- Make sure you have a green ring before expecting any picture
- Connect the camera to the DLink, not the cRIO
- Create a new default robot project, and don't make any changes to it.
- Download the project of course.
- Fireup the default Dashboard
- Verify your Classmate IP address and netmask
The default code and settings expect the camera to be connected via the robot DLink with an IP address of 10.15.29.11
You can build bridges, or you can burn them. The choice is yours. - dlavery [more] 
17-01-2012, 08:48
Threaded Mode