|
|
|
 If my counts are correct, during the official matches 141,077 points were scored, and a minimum of 28,746 frisbees were successfully shot into goals. All without a single decapitation, severed limb, or even one porpoise becoming accidentally entangled in the nets. - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
CIM-U-LATOR CAD file
I drafted Banebots' CIM-U-LATOR so my team (708) could include it on our robot, and we thought we would share it with the general FRC community. Enjoy
 Last edited by Talks Too Much : 18-01-2012 at 11:21. |
|
#3
22-01-2012, 09:18
|
||||
|
||||
Re: CIM-U-LATOR CAD file
Thanks for posting it. We are in the process of order 2 of these units this week.
|
|
#4
22-01-2012, 11:08
|
|||
|
|||
|
Re: CIM-U-LATOR CAD file
Absolutely! Here's a STEP file of the whole assembly. I'm still new to CAD, so tell me if you have any problems with it.
|
|
#5
22-01-2012, 14:53
|
||||
|
||||
|
Re: CIM-U-LATOR CAD file
Imported fine! Just a couple of face repairs needed on one of the parts, but SW took care of this automatically. Thanks for sharing!
One minor question: the Banebots webpage info says that the #10-32 mounting hole pattern on the top of the two plates should form a .75x.75 square when assembled. The dimensions in your model are slightly different. Are your dimensions based off measurements? |
|
#6
22-01-2012, 20:59
|
|||
|
|||
|
Re: CIM-U-LATOR CAD file
Yes, I used the measurements I took of a CIM-U-LATOR we had on hand.
|
|
#7
07-02-2012, 22:06
|
||||
|
||||
|
Re: CIM-U-LATOR CAD file
Talks Too Much is now my favorite user on CD.
 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
