|
|
|
 It is a little known fact that Team 1114 is actually "General Motors Canada and Hogwarts Academy" The whole Niagara FIRST thing is just a cover to keep the magic arts concealed from us muggles. - dtengineering [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
How to import Rectangular Target Processing on robot code
Hi, I would like to know how to successfully integrate the "Rectangular Target Processing.vi" into a seperate robot code. I tried doing it but it did not work. All i did was copy paste the code from "Vision Processing.vi" and replaced it when the one in the robot code. How can i successfully get it to integrate it/?
|
|
#2
17-01-2012, 17:54
|
|||
|
|||
|
Re: How to import Rectangular Target Processing on robot code
There's a Tutorial in the Tutorials section of LabVIEW that explains how to do it.
|
|
#3
17-01-2012, 22:54
|
|||||
|
|||||
|
Re: How to import Rectangular Target Processing on robot code
Read the comment at the top left corner of the Vision Processing example's block diagram. It gives directions specifically tailored for adding it to an existing robot project.
|
|
#4
15-02-2012, 12:00
|
|||
|
|||
|
Re: How to import Rectangular Target Processing on robot code
I was having the same issue until I followed those instructions, now I do not know how to calibrate the camera settings since I have successfully imported it.
Can you give me some guidance?
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
