LabView Help

[Greg McKaskle]

The Axis camera utility doesn't seem to work as it should. There is a bug report about it on the FIRSTFORGE site. I reproduced it on an Axis 206 camera, but I didn't try an M1011.

I'd suggest trying to manually configure the camera.

1. Do a factory reset of the camera by holding reset and powering up the camera -- hold 20 seconds or until you see the LED on front turn on.
2. Set the computer to 192.168.0.2 IP address.
3. Use a web browser to go to 192.168.0.90.
4. Give the camera a root account password such as admin.
5. Log into the camera using root.
6. Click on setup and create an FRC:FRC account.
7. Click to TCP settings and change the camera IP to 10.te.am.11, and I set the router to 10.te.am.1.
8. Hit save.

Please let us know if that corrected the issue as we had not seen this with an M1011 camera.

Greg McKaskle

[plnyyanks]

Originally Posted by Greg McKaskle

I reproduced it on an Axis 206 camera, but I didn't try an M1011.

We also ran into the same problem with the 206 and fixed it the same way