Windriver wont communicate with cRIO

[emusteve]

WOOT!! The motors are moving!

Okay, it never occurred to us that the module positions would be different from the past few years. Combing through the Documentation, I Finally spotted the new module placement table! Moved the parallel module, re-imaged, and now the code is running. Still no printf output, but that's for another thread I think.

BTW, the "Getting Started" guide shows the 8-slot as cRIO-FRCII, and "Gettting Started with C++" says Wind River wants us to use the cRIOFRC_vxworks image for the 8-slot (NOT the cRIOFRCII_vxWorks image). Talk about confusing.

Thanks to everyone for all your suggestions. It's really appreciated!

Now we start on NetConsole and trying out CAN. Wish us luck.

Thanks,
Steve