|
|
|
 If I was making this I would want to not have to use anything smaller than a 3/16" end mill, but 1/8" would be acceptable. Anything smaller and I'd tell the designer to go play in traffic. - Cory [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#4
20-01-2012, 15:52
|
||||
|
||||
|
Re: CANJaguar
It's the one where you set the number and then press the button on the jaguar (the ID). The order makes absolutely no difference (except for the whole "wire can't be too long" thing)
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode