|
|
|
 One day the code will be written first, and then a robot built around it - dag0620 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| One day the code will be written first, and then a robot built around it - dag0620 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#22
22-01-2012, 14:00
|
||||
|
||||
|
Re: Accelerometer Example of New Crio
We also struggled with the ADXL345 in I2C mode. Running the included LabVIEW example the device worked intermittently. I looked at SDA and SCL with an O-Scope and noticed they where kind of floating when communication had error-ed out. My fix for this was to place a 100 ohm pull up resistor on both SDA and SCL. This made the ADXL345 perform wonderfully on the I2C bus. We have implemented this fix on our robot and so far have been very happy with the ADXL345's performance.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode