|
|
|
 Our prototypes are good and running, now just need to do some magic to transform all that wood to aluminum. :eek: - FIRSTMa2104 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Our prototypes are good and running, now just need to do some magic to transform all that wood to aluminum. :eek: - FIRSTMa2104 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#25
23-01-2012, 07:27
|
|||||
|
|||||
|
Re: Electrical Board Mounting
Quote:
If you look close at the Jaguar in the area of the screws, you will see one side has molded into the case V+ and V- while the other side is M+ and M-. The M screws are the motor side and V screws are the side you wire to the PD. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2898 electrical board | FlyingHedgeHog | Electrical | 13 | 03-02-2010 14:59 |
| Mounting on the Control Board | seanl | General Forum | 3 | 06-03-2009 20:46 |
| Mounting the IR board | Aratznes_Scythe | Electrical | 4 | 18-02-2008 02:07 |
| Pneumatics Board/Mounting Components | ASmith1675 | Pneumatics | 2 | 06-02-2008 13:47 |
| Mounting Electrical Parts | SpaceOsc | Rules/Strategy | 21 | 15-10-2004 22:52 |
Threaded Mode