Polycord welding - Chief Delphi

Equally possible is that we're just providing some lunch-break entertainment for the people in the GDC. - wasayanwer97 [more]

		Chief Delphi > FIRST > General Forum
Polycord welding

Thread Tools

Rating:

Display Modes

23-01-2012, 18:25

Tristan Lall Tristan Lall is offline

Registered User

FRC #0188 (Woburn Robotics)

Join Date: Aug 2001

Rookie Year: 1999

Location: Toronto, ON

Posts: 2,484

Tristan Lall has a reputation beyond repute

Re: Polycord welding

Try a laboratory hot plate for the heat source (use an aluminum plate to protect its surface).

Aluminum structural extrusions (e.g. Bosch Rexroth) provide channels of approximately the right size for alignment.

I've never tried to weld it in place. The robot was designed so that the belts could be installed later. We just guessed long with the length, and would have re-welded it if it was too loose.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:23.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.