|
|
|
 Don't feel intimidated, we don't bite =). - nehalita [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't feel intimidated, we don't bite =). - nehalita [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
23-01-2012, 20:38
|
|||
|
|||
|
Re: Ultrasonic sensor help needed
We soldered pwm wires to the sensor according to the diagram given on the sensor website for analog, so it's correct. The soldered wires are a part of a pwm cable that ends with a male connector. This male connector is then connected to a female to female pwm cable that is put into the analog breakout on the cRIO.
We do probably have a DMM lying around. How would i go about testing the sensor? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode