using the frc usb flash drive to format the classmate

[rsisk]

If you place your USB stick into the USB hub, then the USB hub into the classmate it should resolve the Disk Read Error.

I have done this on several classmates with 100% success so far.

[NeatTeam]

Originally Posted by rsisk

If you place your USB stick into the USB hub, then the USB hub into the classmate it should resolve the Disk Read Error.

I have done this on several classmates with 100% success so far.

As I explained in my previous message, the Disk Read Error was already solved and the Classmate was formatted. The problem is that now when it powers on, a black screen comes up with an error message. (check out the previous message)

[Rollie]

I ran into the same problem trying to re-image our classmate E09 using the 8GB thumb drive from 2012. After trying many of the suggestions found in forums, I decided to try and specify a partition size of 5000MB, and not use the entire 8GB drive. After using the usual settings in RMPrepUSB, but entering 5000 instead of MAX, the USB image would then successfully boot on our Classmate, and I was able to re-image for 2013.