problem getting motor control with the 2012 default code

if you need a hammer you use a hammer and not an oscilloscope. - Andrew Schreiber [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
problem getting motor control with the 2012 default code

Thread Tools

Rate Thread

Display Modes

24-01-2012, 20:43

mickey

Registered User

FRC #3843

Join Date: Jan 2012

Location: Kentucky

Posts: 9

mickey is an unknown quantity at this point

problem getting motor control with the 2012 default code

I loaded the default 2012 Labview code to my team's last year's robot, but all of the sidecar functions (relay, DIO, PWM) do not work. I testted setting a solenoid and that turned on and off, but I could not set the pwm motor controller that was on the sidecar.

Any ideas of what I am doing wrong? The wiring seems to be correct, and I am practically using the default code.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:42.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.