|
|
|
 Teams must bring their own water. Water must consist of a low viscosity and at it's maximum width must not be larger than 12 in. - Bkeeneykid [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Teams must bring their own water. Water must consist of a low viscosity and at it's maximum width must not be larger than 12 in. - Bkeeneykid [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#16
24-01-2012, 21:50
|
|||
|
|||
|
Re: Bumper question
Still need clarification about gaps along a frame edge. Assuming Figure 4-1 in the bumper-rule section, and assuming that the displayed bumper segments are such that the portion covering a given edge is 8" (measured from corner to middle of frame), then is there a maximum length of the remaiming exposed frame, or does the amount of exposure not matter?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode