Re: How to Remove Pinion Gear from FP-9015
Pulling the pinion is the easy part. Putting the new one on is where you can easily bend the shaft. I recommend making a fixture to hold the motor square and use an arbor press with a faced push rod and relief hole larger than the shaft so the clearance hole will allow you to press the pinion to the proper height. Never press on the pinion if the shaft is not exposed, as this will Guarrantee a damaged and unusable motor. 
Last edited by Teched3 : 25-01-2012 at 18:30.
Reason: Typos, as usual
|
It's kind of magical how I went from legos to replacing most of the iron in my blood with aluminum, and all thanks to my elementary school science teacher. - Astrokid248 [more] 
25-01-2012, 18:27
Why is there never enough time to do it right, but always enough time to do it again!
Threaded Mode