problem getting motor control with the 2012 default code

Ok guys. What is this? Make Brandon work day? - Brandon Martus [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
problem getting motor control with the 2012 default code

Thread Tools

Rate Thread

Display Modes

25-01-2012, 23:56

mickey

Registered User

FRC #3843

Join Date: Jan 2012

Location: Kentucky

Posts: 9

mickey is an unknown quantity at this point

Re: problem getting motor control with the 2012 default code

I had the crio modules set for last years configuration ( DIO module in slot 4). I changed the DIO module to slot 2 and the robot ran just fine! Thanks.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:57.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.