2nd Most Awaited Q and A Answer?

[Jon Stratis]

RRLedford -

We really don't want the entire rule book to go the way of the bumpers - aka super detailed. Take a look at last year's Inspection Checklist - 1/6 of the entire checklist was about the bumpers! If we do that for everything, Inspections will take hours to go though.

The definition of contiguous really isn't that difficult to understand in this scenario. Anyone saying the entire robot makes any number of appendages "contiguous" is lawyering (or engineering...) the rules. That's just ridiculous. Your robot isn't the appendage.

As for your suggestion of a frame that extends in all directions... that would be against many rules. First, your frame must be fixed and non-articulated (R01-2). So your "frame" that extends in all directions at once would be extending past all edges of the frame perimeter, not just one (G21).

The clear intent of the rules would prohibit extending anything through a corner, as that would pass it through two sides of the frame perimeter. Projecting on a diagonal near the corner, however, is a little less clear in the rules... however as the Q&A emphasizes "single edge" in answering a similar question, I don't think that's legal.


TLDR: Use some common sense and stop trying to lawyer (or engineer) the rules to your advantage. The inspectors and refs will call you on it.