Bumper question

[PAR_WIG1350]

Originally Posted by Jon Stratis

True... however, look at what is more or less "normal" numbering (at least for our team, and I don't remember us being exceptionally large compared to other teams) from the past few years:
http://www.chiefdelphi.com/media/photos/36401
http://www.chiefdelphi.com/media/photos/34968

Those numbers are about 1/3 of the long length of the robot (including the bumper corners), and over half the short length (plus corners) - that's well over what you can get with an 8 inch segment + corners.

Those seem rather wide, the slant seems to be the culprit. Also the spacing between your numbers could be reduced. Vertical, closer numbers should get you down to 8" easily.