Anyone work at Pratt Whitney in Engineering?

[sanddrag]

I have a rather specific question regarding a rather specific part, and I'm wondering if anyone on here by chance works in engineering (preferably mechanical) at Pratt Whitney. If so, send me a PM. Thanks.

[Ether]

Originally Posted by sanddrag

I have a rather specific question regarding a rather specific part, and I'm wondering if anyone on here by chance works in engineering (preferably mechanical) at Pratt Whitney.

I worked at P&W's West Palm Beach gas turbine engine test facility back in '82. I had a condo overlooking the PGA National Golf Course.

[sanddrag]

Well, I may as well post here. I have a print for a part with splines and it references a PWA 350 Class 6 spec. I speculate it's from the 1970s or possibly 1960s. How would I go about finding out what is in this specification. From the measurements on the print, it clearly is not an ANSI spline.

[Ether]

Originally Posted by sanddrag

Well, I may as well post here. I have a print for a part with splines and it references a PWA 350 Class 6 spec. I speculate it's from the 1970s...

Sorry. In the '70s I was at the General Electric Riverworks jet engine plant in Boston.