Jaguar Powers motor with no signal!!!!!

[pfreivald]

Originally Posted by Jon Stratis

Check to make sure you wired the jag correctly - if you hooked the motor inputs to power, and the motor to the power inputs, this will happen (and the Jag will be fried).

You know what stinks? Doing that to all four jags on your drive train at the same time!

[Shaun Coon]

we are only using 2 jags with our drivetrain since there are only 2 CIMS on our drivetrain. we figured out the problem was that i mounted them wrong which led me to wire it wrong dont worry the jags and cims both still work!!!

[dyanoshak]

Originally Posted by Shaun Coon

we are only using 2 jags with our drivetrain since there are only 2 CIMS on our drivetrain. we figured out the problem was that i mounted them wrong which led me to wire it wrong dont worry the jags and cims both still work!!!

The Jaguar may still work, but over time you may see the effects of powering the motor side. Be sure to mark that Jag so that you can tell it apart from the others.

If it acts up in the future, it is most likely from damage it sustained when connected improperly.

-David