Servo not working

[MidnightShades]

We also had this problem, it just needs the jumper as the 2nd poster said.

[jaysun]

Yes, a jumper fixed it. Thanks.

[HoneyBadger4260]

Rookie team having the same problem here. Not as hip to all of the lingo, so a pic would be awesome! Thanks

[Alan Anderson]

There are plenty of pictures and lots of useful information in the Digital Sidecar documentation.

[Stewie0056]

hi,
i am having the same problem with the servos not working with the servo example codes.

i have jumpers on the 6 volt enable pins across from the PWM pins im using for the servos but i cannot get the servos to work with the code.

the only way i have succsefully made the servos work is using the example code for jaguar motor control with the 6 volt enabled.

i think im just overlooking something simple but if someone could point out what i should do to make this work i would greatly appreciate it.

thanks

[ONeill6330]

Same servo issue for myself...
1) Used Arduino and servos move great...
2) Have jumpered pins in both jumpers beside PWM pins and wired in DSC correctly...

Wind Rriver code...
//member variables
Servo *S1;
Servo *S2;

//in Constructor
S1 = new Servo(6); //Pwm pin 6
S2 = new Servo(10); //pwm pin 10


//when enabled in TeleOperator mode
S1->Set(1.0);
S2->Set(0.5);


....does nothing....
any watch dogs or other lines of code needed for these...
???Something in code is not set or included here???
thoughts or ideas....

tried moving servo over to a Jaguar motor and jumpered but no action...
also tried Victor pin but no help either when jumpered.

Solved when I setup DSC to breakout board using 20A fuse...wired wrong....
before I got 1.1V now I get 6V on this PWM.