Axis Camera Won't Stay Configured

My brain is about as full as the ChiefDelphi servers have been lately with all the info from the past few days jammed in there. - Elgin Clock [more]

		Chief Delphi > Technical > Technical Discussion
Axis Camera Won't Stay Configured

Thread Tools

Rate Thread

Display Modes

05-02-2012, 15:26

Joshuamunson Joshuamunson is offline

Registered User

FRC #2996

Join Date: Feb 2012

Location: Colorado

Posts: 16

Joshuamunson is an unknown quantity at this point

Re: Axis Camera Won't Stay Configured

I don't know if this helps or not, but we had a problem with the camera loosing it's ip address every time we would power cycle it. If I remember correctly you plug the camera in and go to its default ip (ours was 192.168.0.90) then go into setup, create an account FRC with password FRC. then set the ip to manual and give it an address that wont interfere with anything else, then save it.
Hope this helps!

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:12.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.