|
Re: Alternate Source for 1/2" Flanged Hex Bearings
Its pretty hard to get those bearings, I have a lot of contacts and they could only find the Andymark bearings. However I did find a .5 inch Flanged Hex bearing with a 1.25 OD I think, those didn't quite work with our design so we went with the Andymark ones.
I did some searching and I found the bearing
http://www.wholesalebearing.com/ufhexbore.html
Hope this helps. Clearly it was 1.5 OD So its a bigger bearing but it might work
- Andrew
__________________
Exploding Bacon 2007-2011
Built and Dangerous (B.A.D) 2011-2012
Community Mentor / School Break 2012-2014
North American Robotics: The MooseEagles Founding Member 2012-Present (VEX U)
|
Note that these comments are based on the 2006 FRC game rules, and they may or may not apply to the 2007 game. Your mileage may vary. - dlavery [more] 
06-02-2012, 12:59
Threaded Mode