|
|
|
 GO OUTSIDE, OR SOMETHING. Go do something other than FIRST for a little while - after all, in January, your life is consumed! - Libby K [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| GO OUTSIDE, OR SOMETHING. Go do something other than FIRST for a little while - after all, in January, your life is consumed! - Libby K [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
08-02-2012, 23:49
|
|||||
|
|||||
|
Re: Banner Signal Issue
Don't use a resistor when connecting it to the robot. Just give it 12 volt power on the blue wire, common on the brown one, and run either white or black to a digital input signal pin on the Digital Sidecar. There's already a pullup to 5 volts on that pin, and it will read the sensor's output just fine as it is.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode