|
|
|
 One career isn't really more prestigious than another; not in and of itself. More than anything it depends on what you do with it. - Matt Leese [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| One career isn't really more prestigious than another; not in and of itself. More than anything it depends on what you do with it. - Matt Leese [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Live C++ help
Hi, I have the following error on my driver station when I enable teleop:
ERROR: A timeout has been exceeded: RobotDrive...Output not updated often enough. ...in Check() in c:/Windriver/workspace/WPILib/MotorSafetyHelper.cpp at line 123 I have that error and it repeats continuously on the driver station. I am deploying SimpleRobot example code. Any solutions? 
|
|
#2
14-02-2012, 18:38
|
|||
|
|||
|
Re: Live C++ help
I dont know if you got this working but looking at your pictures you are plugged into the pins that they call multipurpose I/O and not the I2C port. They is the four pins closest to the NXT connector.
|
|
#3
14-02-2012, 22:15
|
|||
|
|||
|
Re: Live C++ help
Could You provide a picture? I'm not sure what your talking about
|
|
#4
15-02-2012, 01:32
|
||||
|
||||
|
Re: Live C++ help
That's the same thing as what we've been talking about. Look at your own picture. There are two columns of pins, the one closer to the NXT connector are the I2C pins. The other set of pins that you plugged into are actually something else.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
