Red and yellow signal

[jason701802]

The LEDs in the Jag are actually two LEDs, one red and one green, in the same package. To create yellow, both are turned on at the same time, that's why it looks like there are two LEDs.

[thrstein]

Hmm, that's strange, as I could've sworn it was a "pure yellow" flashing light until today... I must've been wrong.

I have already tried the calibration (resetting=calibrating while starting up the jag) without success, but if it actually is just the yellow light, I guess we still have the same problem we did before.

[slijin]

Originally Posted by thrstein

Hmm, that's strange, as I could've sworn it was a "pure yellow" flashing light until today... I must've been wrong.

I have already tried the calibration (resetting=calibrating while starting up the jag) without success, but if it actually is just the yellow light, I guess we still have the same problem we did before.

Did you try calibrating it, as opposed to resetting the calibration?

[thrstein]

Originally Posted by slijin

Did you try calibrating it, as opposed to resetting the calibration?

Yes, but all that happened was a few seconds of red and green flashing lights before it returned to the original signaling.