|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
ADXL345 - too noisy
FIRST Team 1296 is trying to get good data from a ADXL345 connected via I2C. We wrote some 50Hz sample data to a file and the device is working but sure seems noisy and the zero G offsets drifts (more than I would expect). I looking for helpful advice from some CDers that have had success with these sensors.
1 - Did you hard mount them? Or attempt to use some sort of vibration mount? 2 - Did you put bypass caps and/or power caps on the connectors? 3 - How much data did you average to get the zero G offset? 4 - How often did you reset the velocity and/or distance accumulators? 5 - Did you low pass the data? If so, what were the filter parameters? 6 - How reliable were you able to get them? 7 - Anyone tried using the FIFO or offset registers? TIA |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|