How are you pushing down bridge?

[MrForbes]

Originally Posted by wireties

FORST Team 1296 is using a van door motor geared up a bit to push down an arm made with 1" square aluminum extrusion. The arm is 2-pronged, we are hoping a ball (on the bridge) might roll between the prongs and into the gatherer.

You might want to make sure it will count as one appendage, not two. There's been a lot of discussion about this here and on Q&A. It's my understanding that a two pronged thingy is considered two appendages (and thus illegal) unless it's all one contiguous piece outside of the frame perimeter, even as it deploys.