Team 3316 Preview! - Chief Delphi

If I was making this I would want to not have to use anything smaller than a 3/16" end mill, but 1/8" would be acceptable. Anything smaller and I'd tell the designer to go play in traffic. - Cory [more]

		Chief Delphi > FIRST > Robot Showcase
Team 3316 Preview!

Thread Tools

Rate Thread

Display Modes

#13

12-02-2012, 12:16

EngiGirl1053 EngiGirl1053 is offline

Registered User

FRC #1053

Join Date: Jan 2011

Location: Canada

Posts: 4

EngiGirl1053 is an unknown quantity at this point

Re: Team 3316 Preview!

When it's halfway up, it would be a lot more than a foot.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 13:50.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.