|
Encoder Help.
I have an encoder hooked up along with a motor. The encoder reads the motor fine. But, I'm stuck on how to use the the output of the encoder with the motor. So lets say i press button 10 on the joystick. Than it tells the motor to only spin 1/4 a rotation, or 90 degrees. I've been trying every possible idea that i had. Any help is greatly appreciated.
//EDIT\\
I've noticed that In my Driver Station the VOLTS are not updating it stuck at 17.5 VOLTS or something like that. any ideas?
Last edited by mtnteam : 13-02-2012 at 16:05.
Reason: Adding a new problem.
|
Mastering simple skills can be a complex challenge. - Petey [more] 
Threaded Mode