crio setup

[ehochstein]

Is your windows firewall turned off? What is the laptop's IP address?

[bladetech932]

yes the firewall is off. i have tried 10.9.32.1,10.9.32.2,10.9.32.5,10.9.32.6

[ehochstein]

Try 10.9.32.51 also make sure you have it tethered via the ethernet crossover cable.

[Mark McLeod]

Some things to try:

• Disable all other networks on your computer, so that only the Ethernet going out to the DLink-cRIO is Enabled. Do not just turn them off, actually go into the Control Panel and Disable them all.
• Keep all your IP settings as they should be, moving them around can only hurt.
• Use the DLink between your PC and the cRIO and keep everything to Ethernet cables until you get it imaged.
• Anti-virus off, as well as, your Firewall.
• Try a different computer.

[Bharat Nain]

Also make sure you are not using last years imaging tool.. if you're using a laptop with software from previous years. That would work with the old cRio but not the new one (I think). The new one is labeled "FRC 2012 Imaging Tool".