GPIO Tolerance - Chief Delphi

Actually, I forsee two [buttons]: Fire and "Thats the opponents target, you dumb robot" - devicenull [more]

		Chief Delphi > Technical > Electrical
GPIO Tolerance

Thread Tools

Rate Thread

Display Modes

14-02-2012, 20:42

team4213

Registered User

FRC #4213

Join Date: Jan 2012

Location: Bloomington, IL

Posts: 12

team4213 is an unknown quantity at this point

GPIO Tolerance

What are the tolerances for input voltages for the signal pin of the GPIOs? In other words, at what point does the GPIO switch from reporting true (high) to false (low)? Does the signal pin have to be taken to 0 volts (i.e directly connected to ground) or is there some point where a low enough voltage will be considered low (and thus report false)?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:49.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.