|
Re: ADXL345 accelerometer problems
It looks like most of the common causes for this problem have been described very well, but I thought I would add one more possibility for anyone searching this thread. Our team had no connectivity to the accelerometer at first with any cable combination. It turned out that the accelerometer was responding to the alternative address even though no jumper had been added to the board. I tested the jumper with an ohm meter and did not find a short, but the device clearly acted as if it had been programmed with a jumper. If anyone else has trouble with no communications at all over I2C, try both addresses before giving up, even if there is no solder jumper on the board.
__________________
This is the zeroth day of the rest of your life.
|
And like Woodie told us in his talk, all the bad stuff we anguished over will be replaced by the memories of the achievements and good time we had this year. - Wayne C. [more] 
15-02-2012, 10:12
Threaded Mode