CAN timeout - Chief Delphi

Without compromise, engineering would be boring. - Mike Betts [more]

		Chief Delphi > Technical > Electrical
CAN timeout

Thread Tools

Rate Thread

Display Modes

16-02-2012, 17:27

hannigan

Registered User

FRC #2264

Join Date: Feb 2010

Location: Minnesota

Posts: 7

hannigan is an unknown quantity at this point

Re: CAN timeout

Thanks, I double checked it and it seems to be wired correctly. In the db9 connection to the crio, I have the resistor connected between the red and green wire. For the terminator at the end of the daisy chain, I have a rj11 connector with a resistor in the middle two contacts. Is there anything else that I may be looking over?
Thanks

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:48.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.