Need Help with Big Sprocket

I'm so conflicted right now. On one hand, you made the same page as a celebrity. On the other hand.... Justin Bieber. - Akash Rastogi [more]

		Chief Delphi > FIRST > General Forum
Need Help with Big Sprocket

Thread Tools

Rate Thread

Display Modes

17-02-2012, 02:18

Lee Reed

Registered User

FRC #2620

Join Date: Feb 2012

Location: Michigan

Posts: 4

Lee Reed is an unknown quantity at this point

Re: Need Help with Big Sprocket

I'm going to guess you want to do 360 + rotation & don't want to fasten the chain to it but want to keep on revolving. That being said, if I was faced with your problem I would apply a wire wheel to the teeth at frequent intervals to "eat away" the excess tooth width. Don't agonize about the tooth geometry it doesn't have to be perfect it just has to work.
Good luck. Regards.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 11:38.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.