|
|
|
 If my shop was snowed in and my unfinished robot was sitting in there, I'd dig it out with a plastic spoon or melt it out with a Bic lighter if I had to. Every hour counts. If there's a will, there's a way to make it happen. - sanddrag [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Set screw problems
Our team is using chain for our bridge mechanism, and both of the sprockets that we are using have been having set screw problems. I have had to replace 3 set screws (they get stripped),while taking the sprocket on and off their about 7 times. We have drilled into the shafts (putting a dent in them) for the screw to sit in, but one of them still slipped out. What should i do?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode