|
|
|
 I just weighed myself and I have gained two pounds since last Saturday. Thats a sign of a good robotics team. - russell [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I just weighed myself and I have gained two pounds since last Saturday. Thats a sign of a good robotics team. - russell [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Wiring the GTS from the 2008 KoP
We are planning on using the Gear Tooth Sensors from the 2008 KoP with this year's robot. The sensor uses both a Digital I/O connector to connect to DIO on the sidecar, but it also requires a 12V power supply. Where should this 12V supply be connected?
|
|
#2
18-02-2012, 01:10
|
|||||
|
|||||
|
Re: Wiring the GTS from the 2008 KoP
It should be powered by a 20 Amp branch circuit from the Power Distribution Board.
|
|
#3
18-02-2012, 15:33
|
|||
|
|||
|
Re: Wiring the GTS from the 2008 KoP
Okay, that's about the only place I could think of where we could legally get 12V, but it seemed like serious overkill. Thanks for the confirmation!
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
