|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||
|
|||
|
Re: Spike Relay code failing
So does anyone have any suggestions?
|
|
#17
|
|||
|
|||
|
Re: Spike Relay code failing
One non-programming possibility is that there is an intermittent electrical connection somewhere. We had one of those a few years ago, where the IFI controller would lose power when the robot leapt forward, causing the robot to...stop leaping forward. Doesn't sound *exactly* like your situation, but I can see scenarios where something like you are describing might happen.
|
|
#18
|
|||
|
|||
|
Re: Spike Relay code failing
|
|
#19
|
||||
|
||||
|
Re: Spike Relay code failing
It could really be a bad spike also. In fact, one of ours stopped working today randomly as well. We checked all the cables and nothing seemed wrong with them, then we tried a different Spike and it worked fine.
|
|
#20
|
|||
|
|||
|
Re: Spike Relay code failing
|
|
#21
|
||||
|
||||
|
Re: Spike Relay code failing
we were helping a team at the Utah Regional and there connector on the spike wasn't working, we had to take off the case to get the connector in it, also today i tried wiring the spikes and put the PWM cable in wrong and busted the pins off it. So ya, they have been known to have connector issues.
|
|
#22
|
|||
|
|||
|
Re: Spike Relay code failing
You cant plug a relay into a pwm you have to plug it into a relay port right across from the pwm's. And also the b pin on the relay goes to the - one on the dsc.
|
|
#23
|
|||
|
|||
|
Re: Spike Relay code failing
Quote:
Check your power source... |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|