|
|
|
 No, we will not call you a "stupid freshman", we attribute your hasty remark due to lack of expirence, but you will gain that in time. - Mr. Ivey [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| No, we will not call you a "stupid freshman", we attribute your hasty remark due to lack of expirence, but you will gain that in time. - Mr. Ivey [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Using two Jaguars with one encoder
Is it possible to use two Jaguars to control one motor each where both motors are coupled to the same shaft and both Jaguars are controlled using the CAN interface and use feedback from the same encoder? Would we may a Y-cable and connect the encoder outputs to both Jaguars?
Thanks. Phil |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode