|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Electrical changes for 2003
Surpised this hasn't been mentioned before, but there are some great eletrical changes this year!
First is a 120 amp main breaker! Twice the capicity of last years and switch rated! 40 amp breakers for the high load motors! Not a huge huge increase, but will still give us more leway. New charger! 6 amps! Faster charges are always good. The Van door motors are back. The Atwoods are back to, with a 8mm shaft instead of that silly gear. Half inch drill motors! I'm still drooling. We have some serious motor power with all these big bad motors. Any other changes im missing? -Andy A. |
|
#2
|
|||
|
|||
|
that sounds bout right andy, and we're all drooling over those 1/2 inches
|
|
#3
|
|||
|
|||
|
Spec sheets
I would love to drool along, but I don't really know how great they actually are... Does anyone know where the specs for the motors and other parts are located? In the past it has been in an appendix, but from the looks of the manual FIRST didn't plan on including that.
|
|
#4
|
||||
|
||||
|
I have a pretty good atwood data sheet here:
http://www.cvhsrobotics.org/resources.htm I'm still looking for the curves for the bosch drill motor (anyone find it yet?) -Kevin |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| buttons (continued from post in electrical) | rosebud | Programming | 3 | 11-01-2003 17:34 |
| How does your team organize its electrical supplies? | Josh Hambright | Electrical | 8 | 28-11-2002 13:01 |
| Drill motor copper electrical connector | archiver | 2001 | 1 | 24-06-2002 00:57 |
| Pneumatics electrical wiring and programming | archiver | 2001 | 1 | 23-06-2002 23:10 |
| Robot electrical systems rules | Morgan Jones | Rules/Strategy | 5 | 06-01-2002 00:50 |