|
|
|
 ....you can't go to a single FIRST event without someone saying "Hey, Look! It's SuperNerd!" - [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| ....you can't go to a single FIRST event without someone saying "Hey, Look! It's SuperNerd!" - [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Locking the drill motor clutch?
In previous years our tem always used a methods to lock the final ring in place to disable the clutch. I've seen several variations on the same theme - from Dr. Joes Drill Advice - to actually pinning them.
Any ideas for this year? I don't see an obvious way to do it like previous years. Do you think the locking mechanism on the drill is sufficient? Rick Gibbs |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White Paper Discuss: Locking the Bosch 3360 Drill in low gear | CD47-Bot | Extra Discussion | 4 | 05-08-2003 02:10 |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| Emergency drill trade/sell | Anarkissed | General Forum | 3 | 16-02-2003 22:37 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
Threaded Mode