CAN failure!!!!!!!!

[Alan Anderson]

Originally Posted by kuh-nig-its-EL

I don't know about console out.

Make sure it's off. The console's serial communication will interfere with the CAN serial communication. Are you using an older 8-slot or a newer 4-slot cRIO?

[kuh-nig-its-EL]

We are using the newer 4 slot crio. On the console out part, all i know is that it was switched to the left (not towards the modules).

[Anupam Goli]

Please tell me you have withheld your cRIO or have a backup. It would be very hard to debug code if you didn't. if you have, I would try and reimage the cRIO. On the 4 slot, the DIP switches are not hardware switches. Remember, when you are downloading code, have Console Out be on if you want console feedback, off if you don't need it. Make sure your CAN cables are correct. Also, are you using the BlackJaguar or the Grey/Tan one? Only the BlackJaguar has a CAN bus on it.

[kuh-nig-its-EL]

I will double check the the console out switch when i get a chance we do have a back up crio. We are using a black jag.