|
|
|
 71, sponsored by Beatty, was breaking the box apart--not just thinking outside it. - Kevin Ray [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| 71, sponsored by Beatty, was breaking the box apart--not just thinking outside it. - Kevin Ray [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
22-02-2012, 10:16
|
||||
|
||||
|
Re: No communication?
Ok so I formated the cRio and set up the ip adress for it using Measurement & Automation Explorer found in the national instruments. I followed the instructions to do so from this website: http://zone.ni.com/devzone/cda/tut/p/id/7191
When I plugged in the IP adress on Measurement & Automation Explorer i saved and refreshed the max on the cRio and Down at the bottom of the Measurement & Automation Explorer I have a message stating that i have inconsistant IP's. Im using a static IP adress and all the settings i remember. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode