Controls on dashboard

[zaphodp.jensen]

Ok, here we go. This is a short example that encodes a Decimal Numeric, a Boolean, and a string and sends it over UDP from the dashboard to the Robot, at which point it is decoded and sent out in the exact same data types.

You can re purpose this to send data back to the dashboard by switching the port and IP addresses on the UDP reads and writes.

For a more in depth project, I off boarded our vision processing to our dashboard, and sent the target information back to the robot. I can post this code, although it is significantly more in depth than this code.

If you have any other questions, feel free to either PM me, or post on this thread again.

[plnyyanks]

I have some example code attached to this post. Take a look, and I'll gladly answer any questions that might arise.

[demons858]

Thanks a ton

[siggy2xc]

Thanks a ton guys, I'll be trying this out at the next meeting!