Wiring Victor output to both motor and analog in

[Matt Krass]

Originally Posted by Joe Ross

That schematic is for the old analog breakout with the switching power supply. The document is for the new analog breakout. I'm not sure where to find the schematic for the new analog breakout.

Aha, see kids, this is why you also link to a document and a page when you're referencing it, so someone can tell you accurately and quickly why you're wrong Thanks for the heads up Joe.

Still, the general point of my post remains, a divider such as the one shown in the (old) schematic should be valid for your application, as is the point about the low pass filter.... and the fact that you should use an encoder instead

Matt

[Mark McLeod]

Here's version 6

[shuhao]

Voltage divider so it goes down to 6.